ZXP Series 7 User's Manual (en) - Hant

3: Operation
Operator Control Panel (OCP)
Operational
MESSAGE
ALARM
CANCELING
CONFIGURATION DATA
CONTACT OPERATION
CONTACTLESS OPERATION
COOLING
PRINTHEAD TEMPERATURE
COOLING
WAITING TO LAMINATE
DIAGNOSTIC
DESCRIPTION
An error message needs to be cleared before normal operations
can resume.
The Cancel button was pressed, and the current operation is
being terminated.
Configuration data is being transferred from the computer to
the printer.
Contact Smart Card is being encoded; i.e., the card is in position
and data is being transferred.
Contactless Smart Card is being encoded; i.e., the card is in
position and data is being transferred.
Cooling printhead to temperature.
Ready to accept a print job, laminator cooling; e.g., when
switching from 2-sided laminating to 1-sided laminating.
Diagnostic testing in progress.
JOB DATA
Data is being transferred from the computer to the printer.
LAMINATING
Print job received, laminating in process.
MAG OPERATION
MANUALLY INSERT CARD
OFFLINE
PAUSING
A Magnetic Stripe Card is being encoded; i.e., card is in position
and data is being transferred.
Waiting for manual card feed (this function is set via the Card
Setup Tab; see Page 51or Page 77.
Status toggled (offline/online) via the OCP Advanced
Settings Menu.
The Pause button was pressed.
PRINTING
Print job received, printing in process.
READY
Ready and at temperature.
STANDBY
Printer is in “sleep” mode; i.e., power save mode.
WAIT
INITIALIZING
WARMING
WAITING TO LAMINATE
WARMING
PRINTHEAD TEMPERATURE
WARNING
Performing a self test on startup.
Ready to accept a print job, laminator warming; e.g., when
switching from 1-sided laminating to 2-sided laminating, or when
the printer has just powered up and the laminator is warming.
Warming printhead to temperature.
Indicates that additional OCP instructions need to be performed;
e.g., RIBBON LOW, etc.
54 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-001