ZXP Series 7 User's Manual (en) - Hant

2: Installation and Setup
Installing the Windows Printer Driver
Installing the Ethernet Printer Driver
Note • To install the USB driver, see Page 37.
Important • The Ethernet printer need not be in the same subnet as the host. It can be in
different subnet as long as it is reachable from the host.
Step 1. If not already done, connect power to the printer. Turn power ON ( | ).
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Connect the Ethernet port on the rear of the printer to the Ethernet network
connection or directly to the computer’s Ethernet port.
Ensure that the Printer’s power switch in the ON ( | ) position.
Insert the User Documentation and Drivers CD into the CD drive of the host
computer. The Main Menu will open.
From the Main Menu, click Install Printer Driver.
If a Printer and Driver is already installed on your computer, one of the following
Welcome windows will be displayed; otherwise go to, Step 8.
Step 7.
Choose the maintenance operation to be performed:
a. If you are installing a newer version of the driver, select Upgrade to install the
new driver.
b. If you are installing the same version driver, select Modify to install additional
Ethernet or USB printer drivers.
c. Select Remove to remove the current printer driver. When asked about
removing the smart card readers drivers, click Yes to remove them; click No
to leave them installed. At the end of the un-install process, you will be asked
to re-boot your computer.
P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 43