ZXP Series 7 User's Manual (en) - Hant

2: Installation and Setup
Loading the Laminate
Using Partial-Width Laminate (continued)
Step 1. Remove the Lower Laminate Cassette; see Page 21.
Step 2.
Step 3.
Open the cassette, and remove the laminate if present.
Load the partial-width laminate into the cassette. Note that the collar on the laminate
spool is on the end opposite the geared flange.
Collar
Step 4. Trim the partial-width laminate; see Page 24.
Step 5. Rotate the core to adjust the laminate overhang; see Page 25.
Step 6. Install the cassette; see Page 26.
32 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-001