ZXP Series 7 User's Manual (en) - Hant

2: Installation and Setup
Loading the Laminate
Using Partial-Width Laminate
Note • Since partial-width laminates are only used for the back (i.e., lower) surface of the
card, this section only applies to the dual-sided laminator.
Laminates come in three widths:
“Full-Width” laminate is 2 in (51 mm) wide. The full-width laminate is used on the front (i.e.,
upper) or back (i.e., lower) surface of the card.
“Partial-Width” laminate is available in two widths:
• 1.66 in (42mm) wide laminate is used for cards with a writable signature panel
• 1.33 in (33 mm) wide laminate is used for cards with a magnetic stripe
For either partial-width laminate, a collar on the spool keeps the laminate positioned correctly.
2“
Full-Width
1.66“
BACK OF CARD
Signature Panel
1.3”
Magnetic Stripe
P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 31