ZXP Series 7 User's Manual (en) - Hant

2: Installation and Setup
Unpacking the Printer
Caution • The Printer weighs approximately 12.2 kg (26.9 lbs). Use two people to lift it
out of the shipping carton.
Step 5.
Lift the Printer out of the carton by holding it with both hands.
Step 6.
Place the Printer in a location that meets the following requirements:
Important • When moving the printer from storage (23º F/-5º C to 158º F/70º C) to the
operating area (59º F/15º C to 95º F/35º C), allow time to acclimate prior to operation.
• A reasonably dust-free and dirt-free environment.
• Flat surface at least 30 in (762 mm) x 12 in (305 mm) that can support the
weight of the Printer; additional space preferred. Allow a 4-inch clearance,
minimum, on all sides.
• Vertical clearance at least 32 in (813 mm).
• Temperature within the range of 59° to 95°F (15° to 35°C).
• Relative humidity 20 to 80% inclusive, non-condensing.
• Auto-switching single-phase AC Power, 90V~264V AC, 47-63Hz (50-60Hz
nominal); see Electrical specifications on page 145 for power consumption.
Step 7.
Remove the Printer from the protective plastic bag.
P1036101-001 Zebra ZXP Series 7 Card Printer User’s Manual 7