CIMD Interface Specification - Telenor

More documents

Recommendations

Info

710-729 delivery not OK, message level error - 710 - generic failure; the SMS Center sends a negative SR. - 711 - unsupported DCS; the SMS Center sends a negative SR - 712 - unsupported UDH; the SMS Center sends a negative SR. 730-750 delivery not OK, service level error 730 - unknown subscriber; the SMS Center sends a negative SR. Error codes bigger than 700 can be seen in the CIMD2 operator session traces, but are not visible in event logs, and they are mapped as permanent errors. . If the parameter's value is other than between range 700-799, the SMS Center retries message delivery after a certain period of time. Table 22. Negative response parameter for delivery message Number Negative response parameters 900 Error code 5.8 Deliver status report (23) CIMD Interface Specification This operation is used by the SMS Center to send a status report describing the delivery status of a previously submitted message. The generation of status reports for a particular message is requested in the submit operation. The delivery of status reports to the application depends also on the type of application. Querying applications, connecting to an SMS Center, always have to request the delivery of a status report using the enquire message status operation (04). Receiving applications will receive the status report whenever it is available. After a successful delivery of the status report, the status report will be removed from the SMS Center if it describes the final status of the message. The information in the deliver status report message is the same as in the enquire message status response. 36 (77) # Nokia Corporation dn03305755 Issue 5-0 en
5.9 Set (08) dn03305755 Issue 5-0 en Table 23. Deliver status report parameters Number Deliver status report parameters 021 Destination address M 060 Service centre time stamp M 061 Status code M 062 Status Error code O 063 Discharge time M 023 Originator address O Presence Response for deliver status report does not contain any parameters. Example Deliver status report Parameters related to CIMD operations 73:012 This operation is used by the application to change those parameters of the interface profile that it is allowed to change. At the moment, only the password can be changed by applications. # Nokia Corporation 37 (77)
Page 1 and 2: dn03305755 Issue 5-0 en SMSCDOC8100
Page 3 and 4: Contents dn03305755 Issue 5-0 en Co
Page 5 and 6: 1 About this document This document
Page 7 and 8: 2 CIMD2 interface overview dn033057
Page 9 and 10: 3 CIMD operations The operations ar
Page 11 and 12: 3.3 Operations from the SMS Center
Page 13 and 14: dn03305755 Issue 5-0 en Table 4. Op
Page 15 and 16: 4 CIMD protocol messages 4.1 Messag
Page 17 and 18: 4.1.3 Trailer dn03305755 Issue 5-0
Page 19 and 20: Note 4.3 Checksum dn03305755 Issue
Page 21 and 22: 4.4.1 Positive response message Aft
Page 23 and 24: 5 Parameters related to CIMD operat
Page 25 and 26: dn03305755 Issue 5-0 en When the ap
Page 27 and 28: Note A submit to multiple destinati
Page 29: Table 13. Enquire message status pa
Page 32 and 33: Delivery Request -----> 05:007 05:
Page 34 and 35: Table 20. Negative response paramet
Page 38 and 39: 5.10 Get (09) Table 24. Set paramet
Page 40 and 41: Example Application-originated Aliv
Page 42 and 43: CIMD Interface Specification 42 (77
Page 44 and 45: Table 29. Windowing scenario 1 ASE
Page 48 and 49: Example Sending six bytes of binary
Page 50 and 51: Name ID Max Length Originated Visit
Page 52 and 53: Name ID Max Length First Delivery T
Page 54 and 55: Name ID Max Length Delivery Request
Page 56 and 57: Table 32. Parameter error codes and
Page 58 and 59: Table 32. Parameter error codes and
Page 62 and 63: Table 34. Default character convers
Page 68 and 69: Symbol Table 35. Extension characte
Page 72 and 73: Number UDH information 0B Length of
Page 74 and 75: The DCS is coded as defined in ETSI
Page 76 and 77: there ! How are you doing ? Submit

CIMD Interface Specification - Telenor

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?