HD3000 - Janome

!0 !1 !2 !3
!0 Cut the both needle and bobbin threads
leaving about 10 cm (4˝) thread ends.
Draw the needle thread to wrong side of
fabric by pulling the bobbin thread.
Then, knot the threads.
!1 Insert a pin inside the bartack.
Then cut the opening with a seam
ripper.
Take care not to cut the stitches.
!2 To repeat buttonhole sewing.
After a buttonhole is sewn, move the indicator to pattern
“1” ( ) by turning the pattern selector dial in the
direction of arrow 1, then return the indicator back to
“BH” by turning the dial in the direction of arrow 2 to
reset for sewing the next buttonhole.
!3 When buttonhole sewing is
finished, push the buttonhole
lever upward as far as it will go.
31