HD3000 - Janome

More documents

Recommendations

Info

Changing the Sewing Directions Straight Stitching on Heavy Fabrics Stop the machine and bring the needle down into the fabric by turning the handwheel. Raise the presser foot. Pivot the fabric around the needle to change sewing direction as desired. Lower the presser foot. Lower the needle info the fabric at the point where you wish to start sewing. Press the small black button on the zigzag foot with your left hand to “lock” the presser foot to the fabric. Lower the presser foot with your right hand, keeping pressure on the black button with your left hand. Release the black button and start sewing. 24
SECTION IV UTILITY STITCHING Zigzag Stitch Machine Setting Machine Setting Simple zigzag stitch is widely used for overcasting, applique, sewing on buttons etc. Overcasting This type of stitch is used on the seam allowance to prevent fabrics from fraying at raw edges. It can be used to finish a hem edge. Place the edge of the fabric next to the black prong of foot C . 25
Page 1: INSTRUCTION BOOK
Page 4 and 5: Do’s and Don’ts 1. Always be aw
Page 6 and 7: SECTION I ESSENTIAL PARTS Names of
Page 8 and 9: Foot Storage Compartment q w e r Ea
Page 10 and 11: SECTION II GETTING READY TO SEW Con
Page 12 and 13: Pressure Dial Dropping the Feed Dog
Page 14 and 15: To Detach and Attach the Foot Holde
Page 16 and 17: Thread and Needle Chart Fabrics Thr
Page 18 and 19: Threading the Bobbin Winder e r w t
Page 20 and 21: Threading the Machine e r t q w q w
Page 22 and 23: Drawing Up Bobbin Thread q Raise th
Page 24 and 25: Pattern Selector Dial Zigzag Width
Page 28 and 29: Overedge Stitch Tricot Stitch Machi
Page 30 and 31: Sewing Buttons Machine Setting Tape
Page 32 and 33: Touch Starting point r t Bottonhole
Page 34 and 35: Manual Buttonhole Machine Setting q
Page 36 and 37: Corded Buttonhole Machine Setting q
Page 38 and 39: To Sew: Fold back the left seam all
Page 40 and 41: Rolled Hem Machine Setting Make a d
Page 42 and 43: Blind Stitch Hemming Machine Settin
Page 44 and 45: Adjusting Stretch Stitch Balance Sm
Page 46 and 47: Pin Tucking Machine Setting Positio
Page 48 and 49: Applique Patch Work Machine Setting
Page 50 and 51: Cleaning the Hook Race Inserting th
Page 52: Condition Cause Reference Seam Puck

HD3000 - Janome

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?