HD3000 - Janome

Needle Threader
e
q
r
t
u
w
Raise the needle to the
heighest position. Lower the
presser foot.
Pull the needle threader knob
as far as it will go.
q Threader knob
Pass the thread
between the horn
and triangle as
shown.
w Horn
e Triangle
Draw the thread to the left into the
groove on the back.
r Groove
y
Gently push the button.
The pin will push the thread
throgh the needle eye to the
back.
t Button
y Pin
i
Raise the threader knob slowly.
The thead loop is pulled up
throgh the needle eye.
Pull the thread loop to remove
the thread end to the rear.
u Threader loop
i Threader end
The needle threader can be
used with a #11 to #16 needle.
Thread size 50 to 90 should
also work well.
19