HD3000 - Janome

SECTION II GETTING READY TO SEW
Connecting the Machine to the Power Supply
Before connecting the power, make sure the voltage and frequency of your
electrical power conform to the machine.
Switch off the power, fit the nonreversible plug into the machine socket and
plug the machine into the power supply.
Switch on the power.
While in operation, always keep your eyes on the sewing area, and do not
touch any moving parts such as the thread take-up lever, handwheel
or needle.
Always turn off the power switch and unplug from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise the machine will
run intermittently.
Operating Instructions:
The symbol "O" of a switch indicates the "off" position of a switch.
For an appliance with a polarized plug (one blade wider than the other):
To reduce the risk of electrical shock, this plug is intended to fit in a
polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
The foot controller Model YC-482J or TJC-150 is used with this sewing
machine (USA market only).
8