Reaming Tools Catalog - Komet

1
DIHART Reamax ®
Assembly instructions
Clean taper/face contact thoroughly (grease and debris free).
Apply light grease on tie bar thread .
2
Locate tie bar on insert and holder.
Important note: for taper size 3, 4 and 5, fit with marking on
tie bar and insert aligned.
M
Draw in tie bar with the clamping nut. Before tightening, turn
insert and tie bar clockwise until it stops.
Tighten the clamping nut as far as possible using the torque key
to the recommended torque M.
Dia Range
Torque M
0.4724 – 0.6299 (12.000 – 15.999) 35 - 44 in-lbs (4-5 Nm)
0.6300 – 0.8660 (16.000 – 21.999) 53 - 62 in-lbs (6-7 Nm)
0.8661 – 1.0235 (22.000 – 25.999) 88 -106 in-lbs (10-12 Nm)
1.0236– 1.2598 (26.000 – 32.000) 159 - 177 in-lbs (18-20 Nm)
1.2599 – 1.5748 (32.001 – 40.000) 230 - 248 in-lbs (26-28 Nm)
Removing the replaceable head:
Loosen the clamping screw.
Pull tie bar from holder and head.
Locate operating key in head and loosen insert by turning.
Patent applied for inside and outside Germany (Reamax ® )
28