Untitled

› Mae 17
A6000U device represents the most
complete and advanced solution for
non-destructive structural surveys
through ultra-sounds on deep foundations,
infrastructural works or buildings.
The system consists of a computerised
central unit of compact sizes,
to which it is possible to connect, according
to the type of survey, transducers
for surveys in direct contact or
motorised reels controlled electronically,
on which probes are assembled
with high drilling power, for cross-holes
surveys on foundation poles. The central
unit integrates the ultra-sound
generator equipped with 3 channels
with two power levels and the control
electronics for the automatic management
of the probes when being
raised/lowered (cross-hole) and for
saving the data on internal or external
memory of USB type. Thanks to the
user-friendly management software,
all the functions are selected through
menus that can be browsed simply, by
touching the large transflective 10.4”
touch screen LCD monitor. Using the
contact transducers (supplied), it is
possible to use the equipment to test
walls, trusses, partition walls or other
infrastructural works that require direct
surveys or as laboratory analyser
to check specimen, laboratory samples,
rock, stony or plastic materials.
Thanks to the presence of the colourdisplay,
the visualization and interpretation
of the data acquired is easy
and immediate. In the direct analysis
mode, each wave emitted by the internal
generator is visualized in full, and
it is also possible to modify the visualization
parameters to further facilitate
the reading of the crossing speed
and possible presence of defects in
the material inspected. With the use
of 3 probes with simultaneous automatic
operation, A6000U device allows
to save 1/3 of the time needed
for probing, since three relative sections
can be obtained with one single
rising/lowering operation of the
probes in the pole to test (which must
be tested with 3 tubes). The system
carries out an ongoing testing cycle
of the alignment of the probes when
being lowered and raised inside the
holes. The data acquired at each single
pulse is displayed in real time on
the large monitor, allowing an immediate
visualization of possible imperfections
in the structure inspected. The
procedure to carry out cross-hole surveys
with 2 or 3 channels is managed
by A6000/U central unit in automatic
mode. The only operations required
to the operator consist in positioning
the encoders for reading the position
of the motorised probes on the tubes
envisaged for probing and to initially
align the probes on the pole head.
Once this operation has been completed,
the data is acquired by pressing
a button and managed in automatic
mode by the central unit. It is
possible to check the data when acquired,
so as to assess the trend of the
test in real time. It is possible to print
immediately the test reports containing
the data of the probing just carried
out in the construction site.
mae-srl.it/go/A6000U