The Installation Handbook - Howarth Timber

More documents

Recommendations

Info

INSTALLATION 1 Internal Angles Using a 4” taping knife, apply jointing compound to both sides of internal angle. 2 Internal Angles Bed the paper joint tape into corner and cover tape with jointing compound, striking off flush with the plasterboard face. 3 Internal Angles When the tape has set hard or fully dried, apply a second coat of jointing compound, feathering out beyond the edges of the first coat. 82 THE INSTALLATION HANDBOOK 2008
4 Internal Angles When set hard and fully dried, apply a finishing coat of air drying compound or GTEC Allset Xtra, feathering out beyond the edges of the second coat. Now allow the joint to dry fully. 5 Tapered Joints Using a 6” taping knife or trowel, apply jointing compound to tapered joint. 6 Tapered Joints Bed paper joint tape into the compound and cover tape with jointing compound, striking off flush with the plasterboard face. THE INSTALLATION HANDBOOK 2008 83
Page 1 and 2:
PLASTERBOARD The Backing of a World
Page 3 and 4:
Introduction
Page 5 and 6:
What are the values of GTEC The GTE
Page 7 and 8:
Environmental Policy Fulfilling our
Page 9 and 10:
The Lafarge GTEC Direct Bond System
Page 11 and 12:
Table 2: Use of GTEC Universal Bond
Page 13 and 14:
4 Apply vertical dabs at required c
Page 15 and 16:
The Lafarge GTEC Wall Lining System
Page 17 and 18:
STUD Max. Height Guidance Table (m)
Page 19 and 20:
4 Using a disc cutter, drop-saw or
Page 21 and 22:
The Lafarge GTEC Dryliner System is
Page 23 and 24:
Insulation Existing Wall Insulation
Page 25 and 26:
4 Cut each GTEC Dryliner Channel RD
Page 27 and 28:
The Lafarge GTEC Metal Stud System
Page 29 and 30:
Table 1: Components for Metal Stud
Page 31 and 32:
4 Place the ceiling GTEC U Track on
Page 33 and 34: 10 Form as required, one of the fol
Page 35 and 36: The Lafarge GTEC Acoustic Homespan
Page 37 and 38: Skirting Detail A GTEC U Track onto
Page 39 and 40: 4 Place the ceiling GTEC U Track on
Page 41 and 42: 10 Fix the GTEC Acoustic Homespan b
Page 43 and 44: For fixing GTEC plasterboard to tim
Page 45 and 46: GTEC Intumescent Acoustic Sealant a
Page 47 and 48: The Lafarge GTEC Direct to Timber S
Page 49 and 50: Single-layer Boarding Noggins Note:
Page 51 and 52: The Lafarge GTEC Acoustic Floor Sys
Page 53 and 54: GTEC Metal Angle GTEC Acoustic Floo
Page 55 and 56: 4 Fix self adhesive GTEC Resilient
Page 57 and 58: The Lafarge GTEC Dryliner System is
Page 59 and 60: Upgrading existing timber joist flo
Page 61 and 62: 4 Cut the GTEC Dryliner Channel RD1
Page 63 and 64: The Lafarge GTEC Suspended MF Ceili
Page 65 and 66: GTEC Primary Channel GTEC Connectin
Page 67 and 68: 4 Secure the GTEC Ceiling Channels
Page 69 and 70: The Lafarge GTEC T-Bar Corridor Sys
Page 71 and 72: 60 x 60mm rock mineral wool batt TO
Page 73 and 74: 3 Position the boards with long edg
Page 75 and 76: The Lafarge GTEC T-Bar Flat Ceiling
Page 77 and 78: GTEC T-Bar Primary Main T 60x60mm r
Page 79 and 80: 4 Fix GTEC T-Bar Cross T TC1200 to
Page 81 and 82: Lafarge GTEC Taping and Jointing Sy
Page 83: Square and Cut Edge Joints External
Page 87 and 88: 10 Square Edge Joints When set hard
Page 89 and 90: Lafarge GTEC Taping and Jointing Sy
Page 91 and 92: GTEC Cove is a simple and cost effe
Page 93 and 94: 5 100mm GTEC Cove bonded with GTEC
Page 95 and 96: Instructions for marking and cuttin
Page 97 and 98: THIS IS THE CEILING EDGE GTEC Cove
Page 99 and 100: A guide to the GTEC Plasterboard So
Page 101 and 102: GTEC E Board Designed for use in dw
Page 103 and 104: GTEC drywall screws are designed sp
Page 105 and 106: Screws SELF TAPPING SCREWS GTEC Sel
Page 107 and 108: Screws HIGH THREAD SCREWS GTEC High
Page 109 and 110: GTEC Ready Reckoners give a quick g
Page 111 and 112: Wall Linings: Lafarge GTEC Dryliner
Page 113 and 114: Floors and Ceilings: Lafarge GTEC S
show all

The Installation Handbook - Howarth Timber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?