The Installation Handbook - Howarth Timber

3
Position the boards with long edges typically parallel to
the GTEC T-Bar Edge Channel TE3000 with adjoining
edges lightly butted. End joints must occur at the centre
of the GTEC T-Bar Corridor Span T TS2000 section,
staggered by half a board length whenever possible.
Screw fix the plasterboard at 230mm max centres with
drywall GTEC Self Tapping screws on the Span T.
Screw fix the cut edges of the plasterboard at 150mm
max centres to the GTEC T-Bar Corridor Span T TS2000.
Screw fix all perimeter edges to the GTEC
T-Bar Edge Channel TE3000 at 150mm centres.
It is also possible to fix the plasterboard with long edges
parallel to the GTEC T-Bar Corridor Span T TS2000 with
adjoining edges lightly butted.
THE INSTALLATION HANDBOOK 2008
71