EFIS-D6 Installation Guide
EFIS-D6 Installation Guide
EFIS-D6 Installation Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix<br />
Appendix D: Replacing the <strong>EFIS</strong>-<strong>D6</strong> battery pack<br />
1. Remove the three 7/64” hex screws from the battery door of the <strong>EFIS</strong>-<strong>D6</strong>. Do not remove<br />
the Phillips or D-sub screws.<br />
Screw 1<br />
Screw 3<br />
Screw 2<br />
2. If you previously had a battery, disconnect it from the <strong>EFIS</strong>-<strong>D6</strong> by unplugging the battery<br />
connector and gently pulling out old battery. It is safe to gently pull on the battery wire to<br />
remove the battery.<br />
3. Insert the battery with the “bumpy” side up, toward the foam.<br />
4. Connect the battery connector to the battery. The connector is keyed; make sure it is<br />
positioned correctly.<br />
5. Position the connector so it is centered on the end of the pack. Verify battery pack is<br />
properly centered, not under screw 2.<br />
6. Reinsert screw 2 first and tighten to 12 in-lbs.<br />
7. Caution: Screws 1 and 3 are screwed into the extrusion and are easy to over-torque. Press<br />
on the back plate as you insert screws 1 and 3 and tighten to 72 in-ounces.<br />
5-18 <strong>EFIS</strong>-<strong>D6</strong> <strong>Installation</strong> <strong>Guide</strong>