EFIS-D6 Installation Guide

Instrument Installation
Connecting Static & Pitot Lines
The AOA, pitot, and static ports on the back of the
EFIS-D6 are equipped with 1/8” NPT Female
fittings. To attach your pitot and static lines to the
back of the EFIS-D6, you must use standard 1/8”
NPT Male fittings at the end of each of the lines.
To install, simply connect your static and pitot
sources to the EFIS-D6. T’ing off of existing lines
is acceptable if performing a retrofit or connecting
in parallel with other instruments. View the
following back view diagram the placement of your pressure lines.
The EFIS-D6’s attitude calculation
requires either airspeed (from pitot
and static) or GPS data. To ensure
proper operation, at least one of these
data sources must be available. We
recommend the EFIS-D6 be
connected to pitot and static systems
in all installations.
Use two wrenches to both hold the brass fitting on the EFIS-D6 and secure the mating pressure
line fittings to the corresponding locations on the back of the EFIS-D6. Do not over-tighten or
allow the brass fittings to rotate.
If you purchased Dynon’s AOA pitot tube, note that it has pitot and AOA ports on it, but not
static. You will need to provide your own source of static pressure for the EFIS-D6 and any other
instrument in your panel which requires it.
Pitot
AOA
Static
3-10 EFIS-D6 Installation Guide