EFIS-D6 Installation Guide

More documents

Recommendations

Info

Wiring Overview WIRING SYSTEM OVERVIEW The following block diagram depicts the basic layout of the EFIS DB25 electrical connections and is for reference only. Read the specific instructions for each connection prior to installation. The colors shown refer to the Dynon-supplied EFIS harness. 2-4 EFIS-D6 Installation Guide
3. INSTRUMENT INSTALLATION This section provides you with the information needed to physically and electrically install the EFIS-D6. While the EFIS-D6 includes a built-in electronic compass, it is recommended to install and calibrate the included EDC-D10A Remote Compass Module. Selecting a Remote Compass Module Location Finding a good location for the EDC-D10A remote compass module is critical to an accurate EFIS-D6 heading display. Keep in mind that calibration can compensate for small static magnetic fields superimposed upon the earth’s field; it cannot take into account dynamic effects like AC currents, non-constant DC currents and non-stationary ferrous material (e.g., an electric turn coordinator). Use the following suggestions to help you find a good location for your EDC-D10A. • Keep the EDC-D10A away from any source of magnetic fields (such as electrical equipment and currentcarrying wires) and ferrous material. • Move a handheld compass throughout the space surrounding your location to get a rough idea of the suitability of your chosen location. If the needle deviates significantly from magnetic north in any given area, that location would not be ideal for the EDC-D10A. • The EDC-D10A can be mounted anywhere in the aircraft (away from magnetic interference) such that its pitch is as close to that of the EFIS-D6 as possible. It does not need to be directly along any axis of the EFIS-D6. It should be mounted with the long axis parallel to the wings, the electrical connector facing toward the front of the plane, and the mounting tabs on the bottom. The bracket used to hold the EDC-D10A must hold the EDC-D10A at the same pitch, roll, and yaw as the EFIS- D6 with respect to the airframe. We recommend that you use an electronic level, if available, to make sure the EDC- Connector toward direction of flight Connector forward and tabs mounted down Side view of EDC-D10A, tabs mounted down and aligned within 1 degree of pitch with EFIS-D6 EFIS-D6 Installation Guide 3-1
Page 1: EFIS-D6 Installation Guide This pro
Page 5: Table of Contents Contact Informati
Page 8 and 9: Introduction About this Guide In th
Page 10 and 11: Wiring Overview 25-Pin Female EFIS
Page 14 and 15: Instrument Installation D10A is ali
Page 16 and 17: Instrument Installation PC CONNECTI
Page 18 and 19: Instrument Installation SERIAL ALTI
Page 20 and 21: Instrument Installation Panel Locat
Page 22 and 23: Instrument Installation Connecting
Page 24 and 25: EFIS Calibration and Configuration
Page 31 and 32: 5. APPENDIX The appendices contain
Page 33 and 34: Alert Message Description End condi
Page 35 and 36: Appendix Problem Airspeed is inaccu
Page 37 and 38: Appendix Appendix B: Dynon AOA/Pito
Page 39 and 40: Appendix instructions on the follow
Page 41 and 42: Appendix controller. Remember that
Page 43 and 44: Appendix Boom mount PLUMBING NOTE:
Page 45 and 46: Appendix Appendix C: Encoder Serial
Page 47 and 48: Appendix EFIS DB25 Pin# 13 Dynon EF
Page 49 and 50: Appendix Appendix E: Upgrading EFIS

EFIS-D6 Installation Guide

Create successful ePaper yourself

Delete template?

Save as template?