GTP - 32 CONTROL PROCESSOR User Manual ... - DNF Controls
GTP - 32 CONTROL PROCESSOR User Manual ... - DNF Controls GTP - 32 CONTROL PROCESSOR User Manual ... - DNF Controls
3) In the “Old password” entry box, enter the current password. Note: When shipped from the factory, the default password is “controls”, all lower case. 4) Enter the new password in the “New Password” entry box. 5) Enter the new password in the “Verify New Password” entry box. 6) Click on “Save” to save the new password, or click on “Cancel” to exit without changing passwords. Note: If the “New Password” entry and the “Verify New Password” entry do not match, an error will be displayed. SET SYSTEM LABEL The System Label is used to uniquely identify a GTP-32. This name is associated with the IP address. Using the web browser: 1) From the GTP-32 Home Page, click on the “System” link. The System page will be displayed. 2) Click on “Set System Label”. The Set System Label page will be displayed. - 8 -
3) Enter any name made up of letters, numbers, or special characters, up to 16 characters. 4) Click on “Save” to save the name entered in step 3). OR Click on “Cancel” to exiting without changing the System Label. - 9 -
- Page 1 and 2: 12843 Foothill Blvd. Suite C Sylmar
- Page 3 and 4: REVISION HISTORY 2.0 First Draft of
- Page 5 and 6: CONFIGURATION Configuration is requ
- Page 7: SET PASSWORD The default password,
- Page 11 and 12: GPI The GPI Section is responsible
- Page 13 and 14: 3) For each GPI, do the following:
- Page 15 and 16: The GPO Configuration Table will be
- Page 17 and 18: 3) For each channel, enter a channe
- Page 19 and 20: Ethernet Physical Configuration 1)
- Page 21 and 22: c. Heartbeat - Deprecated d. USP_GP
- Page 23 and 24: 4. In the Local Event Label field,
- Page 25 and 26: 1) Combinatorial Event Setup To vie
- Page 27 and 28: 5) Click on “Save and Exit” to
- Page 29 and 30: 4) A confirmation prompt will be di
- Page 31 and 32: not, an error message will be displ
- Page 33 and 34: 1) Click on the Action Definitions
- Page 35 and 36: ADD A ROW TO THE EVENT MONITORING T
- Page 37 and 38: 5) For each selected row, make the
- Page 39 and 40: 2) Delete a Backup File a. On the w
- Page 41 and 42: 4) The Current Log tag notes which
- Page 43 and 44: SPECIFICATIONS Power: 100 VAC - 240
- Page 45 and 46: GPIO CONNECTORS: GPI 1 - 16, GPI 17
- Page 47 and 48: FRONT & REAR VIEWS Front View Rear
- Page 49 and 50: GPI Jumper 1 J7 2 J8 3 J9 4 J10 5 J
- Page 51: LIMITED WARRANTY DNF Controls warra
3) Enter any name made up of letters, numbers, or special<br />
characters, up to 16 characters.<br />
4) Click on “Save” to save the name entered in step 3).<br />
OR<br />
Click on “Cancel” to exiting without changing the System Label.<br />
- 9 -