Ixia Black Book: SDN/OpenFlow

More documents

Recommendations

Info

Test Case: OpenFlow Switch Setup and Functional Test Step by Step Instructions The following steps describe the procedure for performing the test. 1. Reserve one Ixia port Figure 3: Port Selection window 2. Enable OpenFlow by selecting the OpenFlow check box in the RoutingSwitching tab in the Protocols window. Figure 4: RoutinSwitching tab, Protocols window PN 915-2635-01 Rev A December 2012 9
Test Case: OpenFlow Switch Setup and Functional Test 3. Configure the emulated controller IP address and Gateway address from the Connected Interface tab on the Protocol Interfaces window. Use the IP address of the OpenFlow switch if you have only one switch. For Of Channel, ensure that ARP is resolved. Figure 5: Protocol Interfaces window 4. Define the port role by selecting the role from the Port Role list on the Ports tab on the OpenFlow window. You can select any of the following port roles: a. Control: Ixia port will only act as a Controller. b. Traffic: Ixia port will be used as traffic endpoints. c. Control & In-Band Traffic: Ixia port will act as emulated controller as well as traffic endpoints (that is, in-band signaling). Figure 6: Ports tab, OpenFlow window PN 915-2635-01 Rev A December 2012 10
Page 1: ADVANCED MPLS Black Book Edition 8
Page 5: SDN/OpenFlow Contents How to Read t
Page 8 and 9: SDN/OpenFlow Dear Reader Ixia’s B
Page 10 and 11: Introduction - Software Defined Net
Page 12 and 13: Introduction - Software Defined Net
Page 14: Introduction - Software Defined Net
Page 17: Test Case: OpenFlow Switch Setup an
Page 21 and 22: Test Case: OpenFlow Switch Setup an
Page 30 and 31: Test Case: OpenFlow Switch Forwardi
Page 52 and 53: Test Case: Switch Flow Failover Per
Page 68 and 69:
Test Case: Switch Flow Failover Per
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Contact Ixia Corporate Headquarters
show all

Ixia Black Book: SDN/OpenFlow

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?