Morsø 1710
Morsø 1710
Morsø 1710
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation of your <strong>Morsø</strong> <strong>1710</strong> insert stove<br />
There are countless different types of fireplace openings. The following describes several basic<br />
principles which you should follow when installing the insert.<br />
The <strong>Morsø</strong> <strong>1710</strong> can, as described below, be installed in an existing open fireplace. It can<br />
also be installed in a wall opening/chimney built for the purpose.<br />
1. Remove the existing register plate, if any. (Fig. 1)<br />
2. It is easier to adapt the brickwork around the insert when the stove’s heavy inserts are not<br />
sitting inside the steel box. It therefore helps to remove the cast-iron insert from the steel<br />
box:<br />
2.1. Raise the bottom baffle<br />
plate slightly, and ease the two<br />
side bricks out.<br />
2.2.<br />
2.3. Lift the front grate and remove<br />
it from the stove.<br />
The bottom baffle plate can now<br />
be eased down and removed.<br />
2.4. Lift the top baffle plate<br />
slightly so that the two loose<br />
holders at the back can be removed.<br />
20<br />
2.5. The top baffle plate can<br />
then be lifted free of the tertiary<br />
air supply pipe at the front and<br />
tipped down. The plate can now<br />
be removed.<br />
2.6.