LC-42XL2E/S/46XL2E/S/52XL2E/S Operation-Manual GB - Sharp
LC-42XL2E/S/46XL2E/S/52XL2E/S Operation-Manual GB - Sharp
LC-42XL2E/S/46XL2E/S/52XL2E/S Operation-Manual GB - Sharp
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Preparation<br />
Supplied accessories<br />
Attaching the stand unit<br />
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.<br />
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.<br />
CAUTION<br />
• Attach the stand in the correct direction.<br />
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.<br />
1<br />
2<br />
Remote control unit<br />
(g1)<br />
(For Europe, except<br />
U.K. and Eire)<br />
Confirm that there are 8 screws (4 short screws<br />
and 4 long screws) with the stand unit.<br />
Attach the supporting post for the stand unit<br />
onto the base using the 4 long screws with the<br />
hex key (supplied) as shown.<br />
AC cord Cable clamp (g1) Stand unit (g1)<br />
(For U.K. and Eire)<br />
U.K. type 3-pin AC cord is only included with<br />
models <strong>LC</strong>-<strong>42XL2E</strong>, <strong>LC</strong>-<strong>46XL2E</strong> and <strong>LC</strong>-<strong>52XL2E</strong>.<br />
Pages 3 and 6 Page 8<br />
Page 8<br />
Page 5<br />
• <strong>Operation</strong> manual (This publication) • “AAA” size alkaline battery (g2) ... Page 6<br />
Hex key<br />
Long<br />
screw<br />
3<br />
1 Insert the stand into the openings on the<br />
bottom of the TV. (Hold the stand so it will<br />
not drop from the edge of the base area.)<br />
2 Insert and tighten the 4 short screws into the<br />
4 holes on the rear of the TV.<br />
Hex key<br />
Short<br />
screw<br />
Soft<br />
cushion<br />
NOTE<br />
• To detach the stand unit, perform the steps in reverse<br />
order.<br />
5