LC-42XL2E/S/46XL2E/S/52XL2E/S Operation-Manual GB - Sharp

8
Quick guide
Before turning on the power
Standard DIN45325
plug (IEC 169-2)
75 q coaxial cable
Supplying power to the antenna
You must supply power to the antenna in order to
receive digitally/terrestrially broadcast stations after
connecting the antenna cable to the antenna input
terminal on the back of your TV.
1. Press MENU and the menu screen displays.
2. Press c/d to select “Setup”.
3. Press a/b to select “Aerial Setup-DIGITAL”, and
then press OK.
4. Press a/b to select “Supply Voltage”, and then
press OK.
5. Press c/d to select “On”, and then press OK.
* Ferrite Core
The Ferrite Core should be permanently attached
and never removed from the AC cord.
Setting the TV on the wall
• This TV should be mounted on the wall only with the wall mount bracket available from SHARP. (Page 43) The use
of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
• You can ask a qualified service personnel about using an optional bracket to mount the TV to the wall.
• To use this TV mounted on a wall, first remove the adhesive tape at the 2 locations on the rear of the TV, and then use the
screws supplied with the wall mount bracket to secure the bracket to the rear of the TV.
• When you mount the TV on the wall, you should attach the supporting post.
Bundling the cables
Cable clamp
Bundle the
cables with the
clamp.
Ferrite core*
AC cord
1. Carefully insert the
CI Module in the CI slot
with the contact side
forward.
2. The logo on the CI
Module must be facing
forward from the rear of
the TV.
(For Europe, except
U.K. and Eire)
(For U.K. and Eire)
Place the TV close to the
AC outlet, and keep the
power plug within reach.