CR1000 Manual - Campbell Scientific

Section 7. Installation
Figure 39: DevConfig Deployment tab
Datalogger Sub-Tab
• Serial Number displays the CR1000 serial number. This setting is set at the
factory and cannot be edited.
• OS Version displays the operating system version that is in the CR1000.
• Station Name displays the name that is set for this station. The default
station name is the CR1000 serial number.
• PakBus® Address allows users to set the PakBus® address of the
datalogger. The allowable range is between 1 and 4094. Each PakBus®
device should have a unique PakBus® address. Addresses >3999 force other
PakBus® devices to respond regardless of their respective PakBus® settings.
See the PakBus® Networking Guide (available from Campbell Scientific) for
more information.
• Security - See Security (p. 70).
ComPorts Settings Sub-Tab
As shown in figure DevConfig Deployment | ComPorts Settings Tab (p. 101), the
following settings are available for comports.
Read More! PakBus ® Networking Guide available at www.campbellsci.com.
• Selected Port specifies the datalogger serial port to which the beacon interval
and hello-setting values are applied.
99