CR1000 Manual - Campbell Scientific

Section 5. System Overview
5.1.3.5 Communications Ports
• Peripheral 5-Vdc Power Source — 1 terminal (5V) and associated ground (G)
supply power to sensors and peripheral devices requiring regulated 5 Vdc.
Read More! See sections RS-232 and TTL Recording (p. 323), Telecommunications
and Data Retrieval (p. 348), and PakBus Overview (p. 351).
The CR1000 is equipped with six communications ports. Communication ports
allow the CR1000 to communicate with other computing devices, such as a PC, or
with other Campbell Scientific dataloggers.
Note RS-232 communications normally operate well up to a transmission cable
capacitance of 2500 picofarads, or approximately 50 feet of commonly available
serial cable.
• 9-pin RS-232 — 1 DCE port for communicating with a PC through the
supplied serial cable, serial sensors, or through third-party serial
telecommunications devices. Acts as a DTE device with a null-modem cable.
Read More! See the appendix Serial Port Pinouts (p. 549).
Note The 9-pin RS-232 port is not electrically isolated. "Isolation" means
isolated, by means of optical isolation components, from the communications
node at the other end of the connection. Optical isolation prevents some electrical
problems such as ground looping, which can cause significant errors in singleended
analog measurements. Campbell Scientific offers a peripheral optically
isolated RS-232 to CS I/O interface as a CR1000 accessory. Refer to the appendix
Serial Input / Output Peripherals (p. 561) for model information.
5.1.4 CR1000KD Keyboard Display
• 9-pin CS I/O port: 1 port for communicating through Campbell Scientific
telecommunications peripherals. Approved CS I/O telecommunication
interfaces are listed in the appendix Serial Input / Output Peripherals (p. 561).
• 2-pin RS-232: 4 ports configurable from control I/O ports for communication
with serial sensors or other Campbell Scientific dataloggers.
• Peripheral: one port for use with some Campbell Scientific CF memory card
modules and IP network link hardware. See Via CF Card (p. 68) for
precautions when using memory cards.
The CR1000KD, illustrated in figure CR1000KD Keyboard Display (p. 64), is a
peripheral optional to the CR1000. See the appendix Keyboard Displays (p. 567)
for more information on available keyboard displays.
The keyboard is an essential installation and maintenance tool for many
applications. It allows interrogation and programming of the CR1000 datalogger
independent of other telecommunications links. More information on the use of
the keyboard display is available in the sections Read More! To implement
custom menus, see CRBasic Editor Help for the DisplayMenu() instruction.
63