CR1000 Manual - Campbell Scientific

Appendix A. CRBasic Programming Instructions
ArgosTransmit
Initiates a single transmission to an Argos satellite when the instruction is
executed.
Syntax
ArgosTransmit(ResultCode, ST20Buffer)
A.20.2 GOES
GOESData
Sends data to a Campbell Scientific GOES satellite data transmitter.
Syntax
GOESData(Dest, Table, TableOption, BufferControl, DataFormat)
GOESGPS
Stores GPS data from the satellite into two variable arrays.
Syntax
GOESGPS(GoesArray1(6), GoesArray2(7))
GOESSetup
Programs the GOES transmitter for communication with the satellite.
Syntax
GOESSetup(ResultCode, PlatformID, MsgWindow, STChannel,
STBaud, RChannel, RBaud, STInterval, STOffset, RInterval)
GOESStatus
Requests status and diagnostic information from a Campbell Scientific GOES
satellite transmitter.
Syntax
GOESStatus(Dest, StatusCommand)
A.20.3 OMNISAT
OmniSatData
Sends a table of data to the OMNISAT transmitter for transmission via the GOES
or METEOSAT satellite.
Syntax
OmniSatData(OmniDataResult, TableName, TableOption,
OmniBufferCtrl, DataFormat)
OmniSatRandomSetup
Sets up the OMNISAT transmitter to send data over the GOES or METEOSAT
satellite at a random transmission rate.
Syntax
OmniSatRandomSetup(ResultCodeR, OmniPlatformID, OmniChannel,
OmniBaud, RInterval, RCount)
OmniSatStatus
Queries the transmitter for status information.
Syntax
OmniSatStatus(OmniStatusResult)
524