CR1000 Manual - Campbell Scientific

Section 4. Quickstart Tutorial
4.2.5 Send Program and Collect Data
4.2.5.1 Procedure: (PC200W Step 1)
18. Close this window by clicking on X in the upper right corner.
PC200W Support Software Objectives:
This portion of the tutorial will use PC200W to send the program to the CR1000,
collect data from the CR1000, and store the data on the PC.
1. From the PC200W Clock/Program tab, click on Connect button to establish
communications with the CR1000. When communications have been
established, the button will change to Disconnect.
Figure 19: PC200W Connect button
4.2.5.2 Procedure: (PC200W Steps 2 to 4)
2. Click Set Clock to synchronize the CR1000 clock with the computer clock.
3. Click Send Program.... A warning will appear that data on the datalogger
will be erased. Click Yes. A dialog box will open. Browse to the
C:\CampbellSci\SCWin folder, select the QuickStart.cr1 file. Click Open. A
status bar will appear while the program is sent to the CR1000 followed by a
confirmation that the transfer was successful. Click OK to close the
confirmation.
4. After sending a program to the CR1000, a good practice is to monitor the
measurements to ensure they are reasonable. Select the Monitor Data tab.
The window now displays data found in the Public table coming from the
51