CR1000 Manual - Campbell Scientific

Appendix A. CRBasic Programming Instructions
DataInterval
Sets the time interval for an output table.
Syntax
DataInterval(TintoInt, Interval, Units, Lapses)
FillStop
Sets a data table to fill and stop.
Syntax
FillStop
Note To reset a table after it fills and stops, use ResetTable() instruction in the
user program or the support software Reset Tables command.
OpenInterval
Sets time‐series processing to include all measurements since the last time data
storage occurred.
Syntax
OpenInterval
TableHide
Suppresses the display and data collection of a data table in datalogger memory.
Syntax
TableHide
A.2.2 Data Destinations
Note TableFile() with Option 64 is now the preferred way to write data to a CF
card in most applications. See TableFile() with Option 64 (p. 330) for more
information.
CardFlush
Immediately writes any buffered data from CR1000 internal memory and file
system to resident CF card (CRD: drive) or Campbell Scientific mass‐storage
media (USB: drive). TableFile() with Option 64 is often a preferred alternative to
this instruction.
Syntax
CardFlush
CardOut
Send output data to a CF card module. TableFile() with Option 64 is often a
preferred alternative to this instruction.
Syntax
CardOut(StopRing, Size)
DSP4
Send data to the DSP4 display.
Syntax
DSP4(FlagVar, Rate)
476