Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema
Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema
Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Wisotronic</strong> <strong>dialog</strong> 1-<strong>Channel</strong> <strong>Central</strong><br />
<strong>Control</strong> <strong>Unit</strong> <strong>EWFS</strong> ® If the "Wind" sensor or its connecting cable is damaged, the <strong>Wisotronic</strong> cannot<br />
8.3 Duration of the wind<br />
sensor test<br />
evaluate wind measured values and the wind monitoring function does not<br />
function. In order to exclude damage to your sunblind in case of such a defect,<br />
you can activate the wind sensor test. If the <strong>Wisotronic</strong> does not receive a signal<br />
from the "Wind" sensor within a period which can be set (1 to 99 hours), it is<br />
assumed that the sensor is defective. The sunblind is moved up at those channels<br />
at which the wind monitoring function and the wind sensor test are activated. The<br />
following display is shown on the <strong>Wisotronic</strong>:<br />
H<br />
Alert<br />
Wind sensor<br />
T<br />
During this display the comfort functions are not activated. The local operating<br />
points do not have any function either. Take into account that sunblinds are no<br />
longer moved automatically during your absence (holiday, weekend, etc.). The<br />
setting range is from 1 - 99 hours. If a wind sensor test is not desired, you can<br />
also set the value "0" (---) here. The wind sensor test has to be reset<br />
manually. The procedure is described in Section 7.4. Proceed as follows in order<br />
to change the setting:<br />
■ Change to the service settings menu as described above. The following<br />
display appears:<br />
Product<br />
{ }<br />
■<br />
Turn the function dial until the following display appears:<br />
System<br />
settings<br />
{ }<br />
■<br />
Select this menu item (button {). The following display appears:<br />
System<br />
control type<br />
Drive with MCU<br />
— + | }<br />
■<br />
Turn the function dial until the following display appears:<br />
Duration Wind<br />
sensor test<br />
99 hours<br />
— + | }<br />
■ Change the settings by using the buttons — + and then press the button |<br />
(save) If you want to exit the menu without saving the changes, press the<br />
}button twice consecutively. This completes the process.<br />
932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 97