Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ®
To estimate the wind speed you can use the following table:
Windspeed in
m/s
Force
Specifications for use on land
0 - 0,2 0 Calm, smoke rises vertically
0,3 - 1,5 1
Light air, direction of wind shown by smoke
drift, but not by wind vanes
1,6 - 3,3 2 Light breeze, wind felt on face, leaves rustle
3,4 - 5,4 3
Gentle breeze, leaves and small twigs in
constant motion, wind extends light flag
5,5 -. 7,9 4
Moderate breeze, raises dust and loose
paper, small branches are moved.
Fresh Breeze, small trees in leaf begin to
8,0 - 10,7 5 sway; crested wavelets form on inland
waters
Strong Breeze, Large branches in motion;
10,8 - 13,8 6 whistling heard in telegraph wires; umbrellas
used with difficulty.
Near Gale, whole trees in motion,
13,9 - 17,1 7 inconvenience felt when walking against the
wind.
17,2 - 20,7 8
Gale, breaks twigs off trees, generally
impedes progress.
20,8 - 24,4 9
Severe Gale, slight structural damage occurs
(chimney-pots and slates removed)
Storm, seldom experienced inland; trees
24,5 - 28,4 10 uprooted; considerable structural damage
occurs.
28,5 - 32,6 11
Violent Storm, very rarely experienced,
accompanied by wide-spread damage
over 32,7 12 Hurricane
7.3.3 Wind monitoring delay
"UP"
You can assign a delay period to the wind alert separately so that your sunblind is
not moved up at each gust of wind. If the wind limits are reached or exceeded for
the duration of this delay period, the wind alert is triggered and the sunblind is
moved up. At a wind speed above 20 m/s a further safety function of the
Wisotronic is activated. The sunblind is moved up immediately. The activation
delay period is skipped in this case. The setting range is from 0 - 20 seconds.
Proceed as follows in order to change the limit:
■ Change to the wind monitoring menu as described above. The following
display is shown:
Wind
monitoring
ON
— + | }
■
Turn the function dial until the following display appears:
Wind
delay UP
5 seconds
— + | }
■ Change the settings by using the buttons — + and then press the button |
(save) If you want to exit the menu without saving the changes, press the
}button twice consecutively. This completes the process.
932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 89