Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ® First set the turn time. The setting range for the turn time is from 0 to 9.9
seconds. Proceed as follows in order to change the setting:
■ Change to the product settings menu as described above. The following
display is shown:
Product
product type
Outside V.blind
— + | }
■
Turn the function dial until the following display appears:
Product
turn time
1.6 seconds
— + | }
■ Change the turn time by using the buttons — + and then press the button
| (save). If you want to exit the menu without saving the changes, press the
}button twice consecutively. This completes the process.
7.2.4 Maximum slat angle
Then set the maximum slat angle as specified in the table:
■ Turn the function dial until the following display appears:
Product
slat angle max.
80°
— + | }
■ Change the angle by using the buttons — + and then press the button |
(save). If you want to exit the menu without saving the changes, press the
}button twice consecutively. This completes the process.
7.2.5 Minimum slat angle
Then set the minimum slat angle as specified in the table:
■ Turn the function dial until the following display appears:
Product
slat angle min.
-80°
— + | }
■ Change the angle by using the buttons — + and then press the button |
(save). If you want to exit the menu without saving the changes, press the
}button twice consecutively. This completes the process.
84
We reserve the right to carry out improvements
932806A0•816757•7974k0•08.10.2004