Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

More documents

Recommendations

Info

Wisotronic dialog 1-Channel Central Control Unit EWFS ® Setting step Unit Setting Product Product type Runtime UP Runtime DOWN Turn time Slat angle max. Service settings Articulated arm awning Conservatory awning Outside venetian blind Roller shutter Pleated blind Inside venetian blind min:sec min:sec sec Degrees Slat angle min. Control type Wind monitoring Wind monitoring Limit UP Delay UP Delay OFF Ice monitoring Ice monitoring Limit UP Ice alert automatic reset System Integrated temperature sensor offset Duration wind sensor test Degrees Drive direct/ with MCU ON/OFF m/s sec min ON/OFF ° C ON/OFF ° C hrs Software version - Language Language Deutsch/English Fig. 7-6: Custom settings (Service settings) 80 We reserve the right to carry out improvements 932806A0•816757•7974k0•08.10.2004
Wisotronic dialog 1-Channel Central Control Unit EWFS ® Proceed as follows in order to change the product type: 7.2.1 Product type ■ Change to the product settings menu as described above and select a channel. The following display is shown: Product product type Conserv. awning — + | } TIP When you have selected the product type and saved it, the values from the two tables shown at the front are set automatically. If you have carried out changes to the settings beforehand, your values are overwritten completely during saving (this does not apply to the date and time or remote controls already learned). ■ Change the product type by using the buttons — + and then press the button | (save). If you want to exit the menu without saving the changes, press the }button twice consecutively. This completes the process. You have now changed the product type and together with this setting step the Wisotronic has carried out all the sensible settings for the sun protection product used. As a rule you do not have to carry out any further settings, unless you wish to optimize the control behavior further. 7.2.2 Runtimes The runtime of a sunblind is the time which the sunblind requires in order to move from one end setting to the other (for example from top to bottom). If a sun protection product is set as described above, sensible runtime and turn times are also set for this product in the Wisotronic. Normally it is not necessary to intervene here. This section describes how you can nevertheless carry out these adjustments. Experience shows that the runtimes of sunblind products differ. Thus a roller shutter with 150 cm length required a much shorter runtime than a folding arm awning with 300 cm extension. These runtimes can be adjusted to the connected product down to the second at the Wisotronic. You can also set separate runtimes for "UP" and "DOWN" because a sunblind requires more time to move up than to move down. Note: The runtimes are set to mean values in our works. 932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 81
Page 1 and 2:
WAREMA Controls Wisotronic dialog 1
Page 3 and 4:
Table of contents 1. General ......
Page 5 and 6:
Table of contents 7. Service settin
Page 7 and 8:
Wisotronic dialog 1-Channel Central
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30: Wisotronic dialog 1-Channel Central
Page 79: Wisotronic dialog 1-Channel Central
Page 103: Wisotronic dialog 1-Channel Central
show all

Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?