Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ® You can adjust the backlight brightness of the display while non-operative to your
6.12 Dimming the backlight of
the display
requirements: If you prefer an unobtrusive display, which shines unobtrusively
and does not blind during darkness, set a low value. If you prefer a bright display
which also allows reading at a higher ambient brightness, set a higher value.
Proceed as follows in order to change the setting value:
■ Turn the function dial until the following display appears:
User
settings
{
■
Select the menu item (button {). The following display appears:
Sun
control
{ }
■
Turn the function dial until the following display appears:
Display
{ }
■
Select this menu item (button {). The following display appears:
Display
Contrast
50%
— + | }
■
Turn the function dial until the following display appears:
Display backlight
dimmed
50%
— + | }
■ Change the value by using the buttons — + and then press the button
|(save). If you want to exit the menu without saving the changes, press the
}button twice consecutively. This completes the process.
TIP
When the Wisotronic is operated, the display switches to the
maximum backlight brightness. If it is not operated for a
duration of three minutes, the display switches over to the
dimmed brightness set by you.
932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 73