Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

More documents

Recommendations

Info

Wisotronic dialog 1-Channel Central Control Unit EWFS ® This function only makes sense if you have selected a slat product (external 6.7.6 Slat angle after moving down venetian blinds or internal venetian blinds) as the product type. You can specify how the slats are to be set after the down movement has been completed. You can ensure that the sunblind is turned either to let the light through (horizontal, setting 0°) or to view protection (for example +80°). If you move down the sunblind manually you do not have to wait until the sunblind has reached the "Down" position in order to set the slats. The Wisotronic takes over the task of turning open the slats for you automatically if a corresponding programming exists. The following figure illustrates the setting of the slat angle: Positive value: Slats are turned outwards Negative value: Slats are turned inwards Setting 0°: The slats remain in a horizontal position Outside Inside +80° 0° -80° Fig. 6-20: TIP Slat angle at external venetian blinds and internal venetian blinds The product-typical turn time as well as the product-typical turning angle (refer to Section 7.2.3 to 7.2.5) have to be set first. Note: The setting range of the slat angle depends on the settings made in Section 7.2.3 to 7.2.5. Proceed as follows in order to change the operating mode: ■ Change to the manual operation menu as described above. Turn the function dial until the following display appears: Manual angle DOWN 0° — + | } ■ Change the setting values by using the buttons — + and then press the button | (save). If you want to exit the menu without saving the changes, press the } button twice consecutively. This completes the process. 58 We reserve the right to carry out improvements 932806A0•816757•7974k0•08.10.2004
Wisotronic dialog 1-Channel Central Control Unit EWFS ® Via the function keys and with the function dial: 6.7.7 The possibilities of manual operation 6.7.7.1 Function keys / function dial 6.7.7.2 Remote control ® If a comfort function has triggered a move command, it is possible to counteract or stop it. ® If a safety function has triggered, it is not possible to either counteract or stop it. Operation is possible at any time, irrespective of the control system display. ® If a comfort function has triggered a move command, it is possible to counteract or stop it. ® If a safety function has triggered, it is not possible to either counteract or stop it. ® As long as a function key at the control system is pressed, operation with the remote control is not possible. 932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 59
Page 1 and 2:
WAREMA Controls Wisotronic dialog 1
Page 3 and 4:
Table of contents 1. General ......
Page 5 and 6:
Table of contents 7. Service settin
Page 7 and 8: Wisotronic dialog 1-Channel Central
Page 57: Wisotronic dialog 1-Channel Central
Page 103: Wisotronic dialog 1-Channel Central
show all

Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?