Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ® This function only makes sense if you have selected a slat product (external
6.7.6 Slat angle after moving
down
venetian blinds or internal venetian blinds) as the product type. You can specify
how the slats are to be set after the down movement has been completed. You
can ensure that the sunblind is turned either to let the light through (horizontal,
setting 0°) or to view protection (for example +80°). If you move down the
sunblind manually you do not have to wait until the sunblind has reached the
"Down" position in order to set the slats. The Wisotronic takes over the task of
turning open the slats for you automatically if a corresponding programming
exists.
The following figure illustrates the setting of the slat angle:
Positive value: Slats are turned outwards
Negative value: Slats are turned inwards
Setting 0°: The slats remain in a horizontal position
Outside
Inside
+80° 0°
-80°
Fig. 6-20:
TIP
Slat angle at external venetian blinds and internal venetian blinds
The product-typical turn time as well as the product-typical
turning angle (refer to Section 7.2.3 to 7.2.5) have to be set
first.
Note: The setting range of the slat angle depends on the settings made in
Section 7.2.3 to 7.2.5. Proceed as follows in order to change the operating mode:
■ Change to the manual operation menu as described above. Turn the function
dial until the following display appears:
Manual
angle DOWN
0°
— + | }
■ Change the setting values by using the buttons — + and then press the
button | (save). If you want to exit the menu without saving the changes,
press the } button twice consecutively. This completes the process.
58
We reserve the right to carry out improvements
932806A0•816757•7974k0•08.10.2004