Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

More documents

Recommendations

Info

Wisotronic dialog 1-Channel Central Control Unit EWFS ® Here you can specify whether the temperature control is to be activated or not. 6.3.2 Temperature control ON/OFF Proceed as follows in order to change the setting value: ■ Turn the function dial until the following display appears: User settings { ■ Select the menu item (button {). The following display appears: Sun control { } ■ Turn the function dial until the following display appears: Temperature control { } ■ Select this menu item (button {). The following display appears: Temperature control ON — + | } ■ Activate or de-activate the temperature control by using the buttons — + and then press the button | (save). If you want to exit the menu without saving the changes, press the }button twice consecutively. This completes the process. 38 We reserve the right to carry out improvements 932806A0•816757•7974k0•08.10.2004
Wisotronic dialog 1-Channel Central Control Unit EWFS ® Two operating modes are available for the temperature control: 6.3.3 Selecting the operating modes of the temperature control ® Direct control ® Enable sun 6.3.3.1 Direct control This operating mode simply only triggers move commands when limits are exceeded. 6.3.3.2 Enable sun This operating mode can be used to activate/de-activate the sun control. Example: On a cold clear winter day you want the sun to first heat up your conservatory before the sun protection becomes active. After all, the sun is the most inexpensive heating source. You can therefore program the Wisotronic so that the sun control is not activated until a certain inside temperature has been reached. The "Enable sun" operating mode is used to this purpose. 6.3.4 Changing the operating mode Proceed as follows in order to change the operating mode: ■ Change to the temperature control menu as described above. Turn the function dial until the following display appears: Temperature mode Direct control — + | } ■ Change the setting values by using the buttons — + and then press the button |(save). If you want to exit the menu without saving the changes, press the } button twice consecutively. This completes the process. 6.3.5 Internal or external "temperature" sensor As already described earlier, the Wisotronic disposes of a temperature sensor built into the device with which the required measured values can be recorded. Alternatively an additional sensor input is available. Either a sensor for interior temperature or for external temperature can be connected here. You can set which sensor is to be evaluated by the temperature control: ■ Change to the temperature control menu as described above. Turn the function dial until the following display appears: Allocation temp. sensor External — + | } If the value Internal is set, the temperature control evaluates the sensor built into the device. If the value External is set, the temperature control evaluates the sensor which is connected externally. TIP It is not possible to evaluate both sensors! ■ Change the setting values by using the buttons — + and then press the button |(save). If you want to exit the menu without saving the changes, press the } button twice consecutively. This completes the process. 932806A0•816757•7974k0•08.10.2004 We reserve the right to carry out improvements 39
Page 1 and 2: WAREMA Controls Wisotronic dialog 1
Page 3 and 4: Table of contents 1. General ......
Page 5 and 6: Table of contents 7. Service settin
Page 7 and 8: Wisotronic dialog 1-Channel Central
Page 37: Wisotronic dialog 1-Channel Central
Page 89 and 90:
Wisotronic dialog 1-Channel Central
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103:
show all

Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Create successful ePaper yourself

Delete template?

Save as template?