Wisotronic dialog 1-Channel Central Control Unit EWFS - Warema

Wisotronic dialog 1-Channel Central
Control Unit EWFS ® The limit "DOWN" specifies the intensity of brightness at which the sunblind is to
6.1.2 Sun control limit "DOWN"
be moved down. The setting range is from 0 - 99 klx. If you do not want to
evaluate the limit "DOWN", you can also set the value "0" (---) here. Proceed
as follows in order to change the setting value:
■ Change to the sun control menu as described above. Turn the function dial
until the following display appears:
Sun
limit DOWN
35 klx
— + | }
■ Change the setting values by using the buttons — + and then press the
button | (save). If you want to exit the menu without saving the changes,
press the } button twice consecutively. This completes the process.
6.1.3 Sun control delay "DOWN"
A delay can be assigned to the limit "DOWN" so that the sun protection does not
move down immediately whenever the brightness changes (for example when
the sun shines temporarily through an otherwise heavy layer of cloud). This
smooths the movement behavior of the sun protection and thus increases the
comfort. If the limits are reached or exceeded for the duration of this delay period,
the "DOWN" command is triggered and the sun protection is moved down. The
setting range is from 0 - 99 minutes. Proceed as follows in order to change the
setting value:
■ Change to the sun control menu as described above. Turn the function dial
until the following display appears:
Sun
delay DOWN
2 minutes
— + | }
■ Change the setting values by using the buttons — + and then press the
button | (save). If you want to exit the menu without saving the changes,
press the } button twice consecutively. This completes the process.
6.1.4 Sun control position
"DOWN"
The limit "Position" specifies the position to which the sunblind is to be moved
down when the sun control limit is exceeded. The setting range is from 0-100%,
whereby a value of 0% corresponds to the upper end position and a value of
100% to the lower end position. Proceed as follows in order to change the setting
value:
■ Change to the sun control menu as described above. Turn the function dial
until the following display appears:
Sun
position DOWN
100%
— + | }
■ Change the setting values by using the buttons — + and then press the
button | (save). If you want to exit the menu without saving the changes,
press the } button twice consecutively. This completes the process.
26
We reserve the right to carry out improvements
932806A0•816757•7974k0•08.10.2004