EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix<br />
* If an HS34 failure is detected during this condition, the <strong>EFIS</strong> “direct” audio output (tones only)<br />
is automatically re-enabled (fail-over).<br />
Selecting TEST VOICE OUTPUT and then pressing SEL► produces an audible voice test<br />
(“DYNON AVIONICS”) on the audio output line. This allows you to verify connections and<br />
volume on the ground.<br />
The possible voice alerts for both <strong>EFIS</strong> and EMS are listed in the table above.<br />
VALUE Knob Configuration<br />
The VALUE knob changes the ALT and BARO settings and is configured from HSI SETUP ><br />
VALUE KNOB ►.<br />
The VALUE knob can be configured to require an initial push before rotating the knob has any<br />
effect (REQUIRE PUSH: YES / NO).<br />
The “default” mode of the VALUE knob is configured by setting FIRST ACTION: ALT /<br />
BARO to set Altimeter or Barometer mode, respectively.<br />
If REQUIRE PUSH is set to YES:<br />
<br />
<br />
<br />
The first push of the VALUE knob activates the FIRST ACTION mode (ALT or BARO)<br />
and displays a “pop-up” window indicating the current mode and value. Rotating the<br />
knob within 5 seconds changes the value of the FIRST ACTION mode (ALT or BARO).<br />
A second push of the VALUE knob within 5 seconds after rotating the knob de-activates<br />
the VALUE knob and closes the pop-uknob push or knob rotation), the VALUE knob automatically de-activates (times out)<br />
window. If there is no further action (either a<br />
after 5 seconds and closes the pop-up<br />
window.<br />
If, after the first push of the VALUE knob, the knob is not rotated, a second push of the<br />
VALUE knob within 5 seconds activates<br />
the secondary mode of the VALUE knob –<br />
indicated by the mode displayed in the pop-up window.<br />
Pushing the VALUE knob a third time or after a knob rotation (within the 5 second<br />
windows described above) de-activates the VALUE knob and closes the pop-up window.<br />
If REQUIRE PUSH is set to NO:<br />
<br />
<br />
<br />
Rotating the VALUE knob changes the value of the FIRST ACTION mode (ALT or<br />
BARO) and displays a pop-up window indicating the current mode and value. Pushing<br />
the VALUE knob again within 5 seconds of the last knob rotation closes the pop-up<br />
window.<br />
Pushing the VALUE knob without first rotating it activates the secondary mode of the<br />
VALUE knob (ALT or BARO, whichever was not chosen as FIRST ACTION) and<br />
displays a pop-up window indicating the current mode and value. Pushing the VALUE<br />
knob again within 5 seconds of the last knob rotation closes the pop-up window.<br />
If there is no further action (either a knob push or knob rotation) within 5 seconds, the<br />
pop-up window automatically closes.<br />
7-22 <strong>EFIS</strong>-<strong>D100</strong> <strong>Installation</strong> <strong>Guide</strong>