EFIS-D100 Installation Guide - Dynon Avionics

1. INTRODUCTION
This manual provides information about the physical, electrical, and plumbing installation of the
EFIS-D100, EDC-D10A and optional AOA pitot probe purchased from Dynon Avionics.
Additionally, this guide deals with setting up the installation-dependant firmware options.
Because you may not have purchased all the components, you need only read through the
relevant sections of this guide. Information about the operation of this instrument can be found
in the EFIS-D100 Pilot’s User Guide.
The EFIS-D100 uses solid-state sensor technology to give an accurate and easy-to-understand
display. To ensure accuracy in its readings, it is very important that you install the instrument
correctly and perform the specified calibration steps. This installation guide will help you
through that process.
OEM Installations
If your EFIS-D100 is installed by an OEM distributor, you may find that you are unable to
access some menus and settings. Some Dynon distributors customize various areas of the EFIS-
D100 firmware to maintain a consistent pilot experience and minimize integration issues across a
large number of installations. Currently, OEMs can customize access levels to the following
settings on Dynon systems: EMS GLOBAL setup menu, EMS SENSOR setup menu, fuel
calibration, trim calibration, flaps calibration, GPS/NAV setup menu, screen configurations, data
logging, and checklists/data panels. OEM distributors have the option of customizing some or all
of these areas. Please contact your aircraft’s manufacturer if you have any questions about how
your unit has been customized.
Warning
Dynon Avionics’ products incorporate a variety of precise, calibrated electronics. Except for
replacing the optional internal backup battery in EFIS-based products per the installation guide,
our products do not contain any field/user-serviceable parts. Units that have been found to have
been taken apart may not be eligible for repair under warranty. Additionally, once a Dynon
Avionics unit is opened up, it will require calibration and verification at our Woodinville, WA
offices before it can be considered airworthy.
EFIS-D100 Installation Guide 1-1