EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Autopilot <strong>Installation</strong> and Configuration<br />
<strong>EFIS</strong> and the audio output of the AP74 is muted.<br />
* If an AP74 failure is detected during this condition, the <strong>EFIS</strong> “direct” audio output (tones only)<br />
is automatically re-enabled (fail-over).<br />
Selecting TEST VOICE OUTPUT and then pressing SEL► produces an audible voice test<br />
(“DYNON AVIONICS”) on the audio output line. This allows you to verify connections and<br />
volume on the ground. Turn the potentiometer to adjust the volume to your preference.<br />
If an AP74 is not connected or not configured for DSAB, the following message is<br />
displayed:<br />
THIS SETUP MENU IS<br />
DISABLED BECAUSE<br />
NO AP74/76<br />
CONNECTED<br />
STEP 7 – PREPARE FOR FLIGHT TEST ON CLEAR, VFR DAY<br />
The remaining configuration steps are done while flying. At many points, the pilot’s<br />
attention will be divided between documentation, configuring the <strong>EFIS</strong>, and maintaining<br />
situational awareness. Before commencing these configuration steps, ensure that you<br />
have adequate altitude, clear weather, no traffic, no obstructions in the flight path, great<br />
visibility, etc. If possible, bring someone along on the first configuration flight.<br />
If AP behavior, performance, or interference with the controls is cause for concern while flying,<br />
remember that the AP can be disengaged in any of the following ways:<br />
1. Turn off the AP circuit breaker/switch or remove the fuse.<br />
2. Push the Autopilot Disengage pushbutton.<br />
3. In the <strong>EFIS</strong>, Select AP > HDGON - push to turn off Roll servo (changes to HDGOFF);<br />
ALTON - push to turn off Pitch servo (changes to ALTOFF)<br />
4. If you have an AP74 installed, push the AP button (The AP indicator turns off, but the<br />
Mode “armed” lights remain on).<br />
Before commencing the remaining AP configuration steps, verify (on the ground with 0 airspeed<br />
indicated on the <strong>EFIS</strong>) that the AP status indicator displays (for a 2-axis system):<br />
AP:OFF-OFF<br />
Verify the following if you have a GPS installed, configured, and powered on:<br />
Magenta GPS information is displayed on the HSI page.<br />
In the <strong>EFIS</strong> > AP > MODE menu, both the HDG and TRK options are displayed.<br />
6-24 <strong>EFIS</strong>-<strong>D100</strong> <strong>Installation</strong> <strong>Guide</strong>