EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
EFIS-D100 Installation Guide - Dynon Avionics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Appendix<br />
Appendix F: Replacing the <strong>EFIS</strong>-<strong>D100</strong> battery pack<br />
1. Remove the two screws (either #1 Phillips or 7/64” hex, depending on when your unit<br />
was manufactured) from the small, rectangular battery door on the side of the <strong>EFIS</strong>-<br />
<strong>D100</strong>. Remove the battery door. Do not remove any other screws from the case of the<br />
unit.<br />
2. If you previously had a battery, disconnect it from the <strong>EFIS</strong>-<strong>D100</strong> by unplugging the<br />
battery connector and gently pulling out old battery. It is safe to gently pull on the battery<br />
wire to remove the battery.<br />
3. Insert the new battery with the bumpy side up.<br />
4. Connect the battery connector to the battery. The connector is keyed; make sure it is<br />
positioned correctly.<br />
5. Position the connector so it is centered on the end of the pack. Verify that the battery<br />
pack will not interfere with insertion of either of the door screws.<br />
6. Reinsert screws and tighten to 12 in-lbs.<br />
Appendix G: Weights<br />
Adding any new instrument to an aircraft requires the installer to be aware of its weight and how<br />
that affects the overall weight and balance of the plane. The following are the weights of the<br />
<strong>EFIS</strong>-<strong>D100</strong> and associated <strong>Dynon</strong>-supplied sensors.<br />
Installed <strong>EFIS</strong>-<strong>D100</strong> .....................................................................................2 lb 13.5 oz (1.287 kg)<br />
<strong>EFIS</strong>-<strong>D100</strong> + battery..........................................................................................3 lb 4 oz (1.465 kg)<br />
<strong>EFIS</strong> 25-pin wiring harness ................................................................................... 11.2 oz (0.32 kg)<br />
EDC-D10A ............................................................................................................3.6 oz (0.102 kg)<br />
<strong>EFIS</strong> OAT ................................................................................................................3.2 oz (0.08 kg)<br />
Heated AOA/Pitot Probe & Heater<br />
Controller ......................................................11.2 oz (0.32 kg)<br />
Unheated AOA/Pitot Probe......................................................................................5.6 oz (0.16 kg)<br />
<strong>EFIS</strong>-<strong>D100</strong> <strong>Installation</strong> <strong>Guide</strong> 7-35