GE863-QUAD / PY Software User Guide

2.6 Placing a Voice call
GE863-QUAD / PY Software User Guide
1vv0300746 Rev. 1 - 23/10/06
Before a voice call can be placed, it is recommended to check if the mobile is registered on a network
(see par. 2.5.3.1) and if the signal strength is enough to ensure a call can be made (see par. 0).
2.6.1 Voice call device set up
2.6.1.1 Set the device in voice mode
• Send command AT+FCLASS=8
• wait for OK response
NOTE: This command may be omitted if the modifier ";" is added at the end of the ATD command
after the number to be dialed.
2.6.1.2 Set the desired audio path active
The GE863-QUAD / PY has two different audio paths:
- internal microphone/ear (MT)
- external microphone/ear (HF)
Usually the internal path is used for a handset function, while the external is used for handsfree
function. There are two way to switch between these two paths:
- SOFTWARE: by using the command AT#CAP= (with n=1 OR n=2)
- HARDWARE: by setting AT#CAP=0 and setting the AXE input high (internal MT) or low (external
HF).
If only one path is needed, then it is preferable to use the internal one (MT).
TIP: when Hardware control is not needed AXE pin can be left unconnected.
TIP: the audio paths can be switched also during a call in both ways.
• Send command AT#CAP=
where:
= 0 for HARDWARE control with AXE input
= 1 for external HF path (regardless of the AXE input status)
= 2 for internal MT path (regardless of the AXE input status)
• wait for OK response
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Right reserved page 24 of 117