2 0 1 3 P R O D U C T G U I D E VIRACON PRODUCT GUIDE 2013 ...

More documents

Recommendations

Info

HIGH PERFORMANCE COATINGS high performance coatings Coating location Coatings are thin layers of metal applied to glass to improve solar performance. The first coatings utilized on building facades were reflective coatings which provide a mirror-like appearance and reduce solar heat gain by reflecting the sun’s energy away from the building. Today, the most popular coatings applied to glass are low-emissivity (Low-E) coatings. Coatings with low-emissivity properties have low heat transfer properties and offer higher light transmission than traditional reflective coatings. Viracon offers a broad selection of both reflective and Low-E coatings. Our coatings can be applied to clear or tinted glass substrates. In addition, a silk-screen pattern can be applied to the same surface as the coating for excellent solar performance and appearance. The specific coating needed for a given project is typically dictated by a required solar performance or a desired appearance. COATING ON #2 SURFACE insulating 010 <strong>VIRACON</strong> // COMPONENTS & ENHANCEMENTS
HIGH PERFORMANCE COATINGS surface designation When describing glass products there are industry standard recommended surface designations. Each ply of glass has two surfaces. The surface to the exterior of the building is referred to as surface #1, the back of this glass ply is surface #2. For glass units with multiple glass plies, there could be 6 or more surfaces. #3 #3 #3 #1 #4 #1 #4 #5 #1 #4 #5 #2 #2 #6 #2 #6 insulating insulating laminated triple insulating For cooling dominated buildings, the best solar performance is achieved when the coating is applied to the #2 surface, therefore Viracon coatings are located on the #2 surface. NEW For increased improvement in center of glass u-value performance, our new RoomSide Low-E is a coating offered on the interior glass surface (the room-side) of an insulating unit. In a typical 1” insulating unit, the RoomSide Low-E coating would be on the #4 surface (interior glass surface) in addition to a Viracon high-performance coating on the #2 surface. NEW Learn more at viracon.com. <strong>VIRACON</strong> // COMPONENTS & ENHANCEMENTS 011
Page 1 and 2: P R O D U C T G U I D E 2 0 1 3
Page 3: CONTENTS 001 INTRODUCTION 003 COMPO
Page 7 and 8: GREAT BUILDINGS DESERVE GREAT GLASS
Page 9 and 10: ENTS & EMENTS
Page 11 and 12: How to turn ordinary glass into ext
Page 13 and 14: GLASS SUBSTRATES GLASS SUBSTRATES G
Page 15: GLASS SUBSTRATES Glass Substrate Lo
Page 19 and 20: HIGH PERFORMANCE COATINGS coating a
Page 21 and 22: SPANDREL GLASS INSULATING GLASS INS
Page 23 and 24: SPANDREL GLASS matching spandrel an
Page 25 and 26: SILK-SCREEN PROJECT DETAIL United S
Page 27 and 28: SILK-SCREEN VIRASPAN DESIGN- origin
Page 29 and 30: SILK-SCREEN orientation Pattern pla
Page 31 and 32: SILK-SCREEN specifying silk-screen
Page 33 and 34: SILK-SCREEN ceramic frit coverage r
Page 35 and 36: DigitalDistinctions DigitalDistinct
Page 37 and 38: HEAT TREATment Heat Treatment Defin
Page 39 and 40: holes GUIDELINE FOR HOLE SPACING Th
Page 41 and 42: NOTCHES NOTCHES Fabricated on our Z
Page 43 and 44: edgework EDGEWORK OPTIONS Type Desc
Page 45 and 46: FEATURE PROJECTS international gem
Page 47 and 48: NG GLASS
Page 49 and 50: Keep Buildings Warm In The Winter,
Page 51 and 52: PRODUCT CONFIGURATIONS PRODUCT COMP
Page 53 and 54: PRODUCT CONFIGURATIONS INSULATING L
Page 55 and 56: PRODUCT CONFIGURATIONS russell inve
Page 57 and 58: PRODUCT CONFIGURATIONS LAMINATED IN
Page 59 and 60: PRODUCT CONFIGURATIONS TRIPLE INSUL
Page 61 and 62: PRODUCT CONFIGURATIONS PROJECT DETA
Page 63 and 64: PRODUCT COMPONENTS SPACERs MATERIAL
Page 65 and 66: PRODUCT COMPONENTS SILICONE Viracon
Page 67 and 68:
PRODUCT COMPONENTS SPACER FILL 1" C
Page 69 and 70:
TELUS TOWER LOCATION: TORONTO, Onta
Page 71 and 72:
PERFORMANCE DATA TABLES Insulating
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Insulating Laminated Low-E (Air Fil
Page 81 and 82:
PERFORMANCE DATA TABLES Triple Insu
Page 83 and 84:
PERFORMANCE DATA TABLES SILK-SCREEN
Page 85 and 86:
PERFORMANCE DATA TABLES VE1-42 INSU
Page 87 and 88:
PERFORMANCE DATA TABLES VRE1-38 INS
Page 89 and 90:
PERFORMANCE DATA TABLES 800 N Glebe
Page 91:
ED GLASS
Page 94 and 95:
laminated GLASS LAMINATED The most
Page 96 and 97:
PRODUCT COmponents interlayers Inte
Page 98 and 99:
product applications laminated glas
Page 100 and 101:
Glass Size Laminated glass sizes Gl
Page 102 and 103:
PERFORMANCE DATA TABLES VIRACON VS
Page 104 and 105:
MONO
Page 106 and 107:
INSULATING GLASS OVERVIEW 100 VIRAC
Page 108 and 109:
MONOLITHIC GLASS PRODUCT Monolithic
Page 110 and 111:
PERFORMANCE DATA TABLES MONOLITHIC
Page 112 and 113:
eso
Page 115 and 116:
The beautiful, uniform foundation o
Page 117 and 118:
Specification Example Division 08 -
Page 119 and 120:
Specification Example 1.3 SUBMITTAL
Page 121 and 122:
Specification Example PART 2 - PROD
Page 123 and 124:
Specification Example C. Laminated
Page 125 and 126:
Specification Example D. Insulating
Page 127 and 128:
Specification Example d. Pattern Or
Page 129 and 130:
Specification Example PART 3 - EXEC
Page 131 and 132:
Quality Standards Pattern Orientati
Page 133 and 134:
glazing guidelines glass handling a
Page 135 and 136:
GLOSSARY GlOSSARY Acoustics: The sc
Page 137 and 138:
GLOSSARY Lite: Another term for a p
Page 139 and 140:
GLOSSARY Ultraviolet Light (UV): Th
Page 141:
Trademarks SentryGlas® is a regist
Page 144:
viracon.com 800 Park Drive, Owatonn
show all

2 0 1 3 P R O D U C T G U I D E VIRACON PRODUCT GUIDE 2013 ...

Create successful ePaper yourself

Delete template?

Save as template?