Sensys Stud Trial - Sensys Networks

Sensys Stud Trial
6.4 Cost Comparison for Typical Installation
6 Lanes Spread Over 2 Carriageways
In this example a site such as Penrose with 2 carriageways and 3 lanes per carriageway. It is
assumed that that all the necessary communications infrastructure is in place, including an
Ethernet switch for the detector hardware to connect to.
Inductive Loop Detector
It is assumed that there is sufficient space in the existing communications cabinet to house the
loop detector.
Description Cost Qty Total Note
Install loops 3 lanes $ 8,090.00 2 $ 16,180.00 Detail found in section 5.1
Cut NB tails across
carridgeway $ 522.00 1 $ 522.00
Hardware Supply $ 10,478.13 1 $ 10,678.47 Detail found in section 5.3
Install Hardware in Existing
Cabinet $ 87.00 4 $ 348.00 2 techs 2 hours
Install tody $ 127.00 2 $ 254.00
1 in centre island, 1 by
cabinet
Trench from toby to cabinet $ 58.00 10 $ 580.00
Assume cabinet 10m from
toby
Cable from toby to cabinet $ 21.00 15 $ 315.00 Extra 5m for slack
Connect and test $ 87.00 6 $ 522.00 2 techs 3 hours
$ 29,399.47
Sensys Detector
Description Cost Qty Total Note
Install studs 3 lanes $ 7,450.02 2 $ 14,900.04 Detail found in section 5.1
Hardware Supply $ 10,478.13 1 $ 10,478.13 Detail found in section 5.3
Install Accesspoint and Cable $ 87.00 4 $ 348.00 2 techs 2 hours
Semistatic to install Access
Point $ 300.00 2 $ 600.00
Install Repeater $ 87.00 2 $ 174.00 2 techs 1 hours
Semistatic to install repeater $ 300.00 1 $ 300.00
Trench from pole to cabinet $ 58.00 10 $ 580.00 Assume cabinet 10m from toby
Connect and test $ 87.00 6 $ 522.00 2 techs 3 hours
$ 27,902.17
Commercial in Confidence Page 27