Sensys Stud Trial - Sensys Networks

More documents

Recommendations

Info

Sensys Stud Trial Contact Closure Card The Contact Closure Card was installed in the existing TDM Signal Controller Cabinet and connected to the external inputs of the QTC Signal Controller. Figure 5. Contact Closure Rack in Signal Controller Cabinet A CAT 5 cable was installed between the Contact Closure Card and the existing TDM network switch. A second CAT 5 cable was installed between the Access Point and the Access box which provided power and data to the Access Point. Commercial in Confidence Page 12
Sensys Stud Trial 3.5 Installation of Wireless Sensor Stud The studs were installed in a 102mm diameter, 120mm deep hole using a coring drill. This process is detailed on the following pages. Figure 6. Typical Sensys Installation 1. A semi-static closure was installed according to COPTTM to close 2 lanes of the carriageway. Commercial in Confidence Page 13
Page 1 and 2: Transfield Services Sensys Stud Tri
Page 3 and 4: Sensys Stud Trial Contents 1. Summa
Page 5 and 6: Sensys Stud Trial Stage 1 concluded
Page 7 and 8: Sensys Stud Trial Figure 1. Typical
Page 9 and 10: Sensys Stud Trial 3.3 Equipment Set
Page 11: Sensys Stud Trial 3.4 Site Layout S
Page 15 and 16: Sensys Stud Trial 5. The sensor wil
Page 17 and 18: Sensys Stud Trial 4. Data Collectio
Page 19 and 20: Sensys Stud Trial 4.2 Data Collecti
Page 21 and 22: Sensys Stud Trial 5.1 First Set of
Page 23 and 24: Sensys Stud Trial 6. Cost Compariso
Page 25 and 26: Sensys Stud Trial 6.2 Cost Comparis
Page 27 and 28: Sensys Stud Trial 6.4 Cost Comparis
Page 29 and 30: Sensys Stud Trial 2 sites of 8 Lane
Page 31 and 32: Sensys Stud Trial 2 sites of 8 Lane
Page 33 and 34: Sensys Stud Trial Appendix A - Resu
Page 35 and 36: Sensys Stud Trial Appendix B - Resu
Page 37: Sensys Stud Trial Sensys Data Analy

Sensys Stud Trial - Sensys Networks

Create successful ePaper yourself

Delete template?

Save as template?