Installation Instructions - Trend Controls
Installation Instructions - Trend Controls
Installation Instructions - Trend Controls
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
11 CONC 12<br />
NO 14<br />
A2 coil A1<br />
11 CONC 12<br />
NO 14<br />
A2 coil A1<br />
11 CONC 12<br />
NO 14<br />
A2 coil A1<br />
<strong>Installation</strong> <strong>Instructions</strong><br />
SRMV<br />
Single Relay Module (Voltage)<br />
Important: Retain these instructions<br />
1 UNPACKING<br />
SRMV <strong>Installation</strong> Instruction<br />
91-2853<br />
2 STORING<br />
-40 °C<br />
(-40 °F)<br />
+70 °C<br />
(+158 °F)<br />
3 INSTALLATION<br />
0 <br />
0 %RH 95 %RH<br />
It is recommended that the installation<br />
should comply with the HSE<br />
Memorandum of Guidance on<br />
Electricity at Work Regulations 1989.<br />
For USA install equipment in<br />
accordance with the National<br />
Electric Code.<br />
15.5 mm<br />
(0.61”)<br />
1 Dimensions relay contact<br />
2 Requirements<br />
terminals<br />
coil terminals<br />
a<br />
A2 coil A1<br />
NO 14<br />
11 + <br />
+ 12<br />
75.5 mm (2.97”)<br />
42 mm (1.65”)<br />
SRMV/USA: the unit<br />
is UL rated as<br />
‘UL916 listed open<br />
energy management<br />
equipment<br />
accessory’.<br />
c<br />
-25 °C<br />
(-13 °F)<br />
+85 °C<br />
(+185 °F)<br />
0 0 %RH 90 %RH<br />
Protection: IP20<br />
(NEMA1)<br />
SRMV <strong>Installation</strong> <strong>Instructions</strong> 91-2853 Issue 3/C 22/11/06 1
)<br />
*<br />
+<br />
,<br />
$ % & ' <br />
8<br />
! " # $ % & ' ! " #<br />
" 8<br />
, 2<br />
<br />
6 : 4 :<br />
! " # $ % & ' <br />
) <br />
SRMV<br />
<strong>Installation</strong> <strong>Instructions</strong><br />
3 INSTALLATION (Continued)<br />
3<br />
Fit to DIN rail<br />
b<br />
a<br />
Standard top hat DIN rail (DIN 46277-3, EN50022, BS5584:1978)<br />
4<br />
To Mount on Flat Surface<br />
a<br />
b<br />
Ø 3 mm<br />
(0.118”)<br />
c<br />
d<br />
5<br />
Switch off IQ<br />
6<br />
Ensure IQ Output channel<br />
is Analogue set to Voltage<br />
IQ<br />
IQ<br />
<br />
1<br />
SIG<br />
0 V<br />
V<br />
IQ Controller<br />
<strong>Installation</strong> <strong>Instructions</strong><br />
2<br />
SRMV <strong>Installation</strong> <strong>Instructions</strong> 91-2853 Issue 3/C 22/11/06
<strong>Installation</strong> <strong>Instructions</strong><br />
SRMV<br />
3 INSTALLATION (Continued)<br />
7<br />
Wire module to controller<br />
Terminal size 2 x 2.5 mm 2 (11 AWG) wires - Cu only<br />
I = 17.5 mA<br />
IQ<br />
SRMV<br />
SIG<br />
0 V<br />
A2<br />
Relay<br />
A1 coil<br />
A2 coil A1<br />
NO 14<br />
11 + <br />
+ 12<br />
polarity independent<br />
8<br />
Ensure HVAC Equipment Power Supply is Switched off<br />
<br />
1<br />
Power Supply<br />
SRMV<br />
HVAC<br />
Equipment<br />
Power<br />
9<br />
Connect Relay to HVAC Equipment<br />
250 Vac @ 8A (resistive), 5A (inductive,<br />
cos ø>=0.4)<br />
20 Vdc @ 8A (resistive)<br />
24 Vdc @ 2A (inductive, T
11 CONC 12<br />
NO 14<br />
A2 coil A1<br />
OK<br />
TX RX<br />
12345678910<br />
LAN<br />
)<br />
*<br />
+<br />
,<br />
<br />
$ % & ' <br />
8<br />
6 : 4 : ) <br />
" 8<br />
! " # $ % & ' ! " #<br />
! " # $ % & ' <br />
, 2<br />
SRMV<br />
<strong>Installation</strong> <strong>Instructions</strong><br />
3 INSTALLATION (Continued)<br />
10 Close panel<br />
11 Switch on IQ<br />
IQ<br />
SRMV/USA. The unit is UL rated as ‘UL916<br />
listed open energy management equipment<br />
accessory.<br />
<br />
1<br />
12<br />
Switch on HVAC Equipment Power Supply<br />
<br />
1<br />
Power Supply<br />
SRMV<br />
HVAC<br />
Equipment<br />
Power<br />
13<br />
Check Relay operation<br />
IQ<br />
DP<br />
‘click’<br />
A<br />
B<br />
C<br />
D<br />
16 17 18 19 20<br />
V<br />
24V<br />
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15<br />
A2 coil A1<br />
SRMV<br />
NO 14<br />
11 CO + 12<br />
HVAC<br />
Equipment<br />
4 DISPOSAL<br />
WEEE Directive :<br />
At the end of their useful life the packaging,<br />
and product, should be disposed of by a<br />
suitable recycling centre.<br />
Do not dispose of with normal household waste.<br />
Do not burn.<br />
Manufactured for and on behalf of the Environmental and Combustion <strong>Controls</strong> Division of Honeywell Technologies Sàrl, Ecublens, Route<br />
du Bois 37,Switzerland by its Authorized Representative, <strong>Trend</strong> Control Systems Limited.<br />
<strong>Trend</strong> Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content hereof<br />
without obligation to notify any person of such revisions or changes.<br />
<strong>Trend</strong> Control Systems Limited<br />
P.O. Box 34, Horsham, West Sussex, RH12 2YF, UK. Tel:+44 (0)1403 21888 Fax:+44 (0)1403 241608 www.trend-controls.com<br />
<strong>Trend</strong> Control Systems USA<br />
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel: (425)897-3900, Fax: (425)869-8445 www.trend-controls.com<br />
4<br />
SRMV <strong>Installation</strong> <strong>Instructions</strong> 91-2853 Issue 3/C 22/11/06