Agilent Technologies N2600A WireScope 350 User's ... - messkom.de

Setting Up an Autotest 4-9
Opening the Settings Menu 4-9
Choosing the Test Configuration 4-10
Setting the Loss Limit 4-10
Setting the Length Limit 4-13
Choosing the Network Limit 4-14
Entering the Site Name 4-15
Choosing the Labeling Format 4-16
Choosing the Cable Type 4-16
Setting the Modal Bandwidth 4-18
Choosing the Connector Type 4-18
Entering the Operator Names 4-20
Running an Autotest 4-22
5 Saving Test Results
Test Results Display 5-2
Saving Test Results 5-3
Choosing the Data Storage Location 5-3
Saving the Results 5-4
Viewing Result Details 5-5
Interpreting Test Results Detail Screens 5-7
6 Expert Mode for Copper Testing
About Expert Mode 6-3
Changing to Expert Mode 6-3
The Expert Autotest Setup 6-4
Choosing an Existing Settings Profile 6-4
Editing an Existing Settings Profile to Remove a Lock 6-5
Creating a New Settings Profile 6-6
Setting the Test Limit 6-8
Viewing Probe Information 6-9
Setting Network Limits 6-10
Entering the Site Name 6-11
Choosing the Labeling Format 6-12
Choosing the Cable Type 6-12
Choosing the Connector Type 6-13
Choosing the Cable Pairing Convention 6-13
Setting the Measurements 6-14
Setting the Maximum Frequency 6-16
Setting the Plot Storage Requirements 6-16
Setting the Storage Location 6-17
Setting the Operator Names 6-17
WireScope 350 User’s Guide vii