Agilent Technologies N2600A WireScope 350 User's ... - messkom.de

��������������
�����������������������
External and Battery Power
2−2
Using External Power
The WireScope 350 and DualRemote 350 are powered by NiMH
rechargeable batteries. These batteries contain circuitry that reports
their state of charge to the WireScope. The units can also be powered by
external an ac/dc power adapters. Connecting the adapters also charges
the batteries.
A fully charged battery can run the WireScope for 5-6 hours before
requiring recharging. The DualRemote’s lack of an LCD screen allows it
to run longer on a charge. Reducing screen brightness and enabling the
Sleep function allows the WireScope to run longer on a charge.
To power the WireScope or DualRemote with AC power, or charge their
batteries:
1 Choose either the 110 Vac to 12 Vdc adapter (N2595A-110), or the 220
Vac to 12 Vdc adapter (N2595A-210), depending on the supply in the
building.
�������� ���Ã����Ã���Ã��������Ã�������Ã��������Ã��Ã���Ã���������Ã����Ã�����Ã�����Ã�����Ã
��������������������������������������������������
Removing the Battery
2 Connect the end of the adapter’s cable to the charging jack on the
side of the unit. See Charging port, on page 1-3.
3 Plug the body of the adapter into an appropriate ac source.
The batteries are located on the back of the WireScope and DualRemote.
To remove a battery:
1 Turn the unit off and disconnect the external adapter.
2 Fully open the stand on the back of the unit.
3 Pull the battery release tab toward the bottom of the unit and out.