Land Rover TestBook User Manual - Eng - Internet-Tools.co.uk

HARDWARE
CLEANING TESTBOOK (TESTBOOK 1)
It is important to clean the touch screen periodically
to maintain proper operation. This is best done when
TestBook is turned off - but if you need to remove
contamination while the TestBook is in use, first
touch the upper left corner of the screen, next to the
screen number. You will then see a message "The
display may be wiped now" - and it will be possible
to wipe the screen without all the buttons trying to
respond at once !
For the screen glass and other outer surfaces of
TestBook, use a mild, non-abrasive liquid cleaner.
Never spray or pour any type of cleaner directly onto
any part of TestBook - instead, use a soft cloth to
apply a small amount of cleaner. For particularly
tough stains, use a small amount of glass cleaner on
a soft cloth.
CLEANING TESTBOOK (TESTBOOK 2)
Before you clean TestBook, follow these steps:
1. Shut off the power to TestBook by toggling the
power button to "0" and unplugging the power
cord from its power source and the TestBook.
2. Inspect TestBook cables, connectors and
power cord for any damage or corrosion. If
damaged, replace them immediately.
3. Inspect the display window, cable assemblies
and connectors for any contaminants.
CAUTION: Do not use chlorinated solvents
to clean TestBook.
NOTE: Although TestBook is moisture
resistant, it is not moisture proof. Dry
TestBook off thoroughly after cleaning it.
Cleaning the Base Unit
Wipe the top and bottom covers clean using a soft
cloth and mild detergent or hand soap. Avoid using
petroleum based solvents such as acetone, benzene
or tricloroethylene. They contain chemicals that can
etch plastic surfaces.
Cleaning the Display Window
The display window collects grime during normal
use. Touch the top left hand corner of the touch
screen to "freeze" the screen. Wipe the screen with
a clean, soft, static free cloth. Use a non-abrasive
plastic cleaner and a soft cloth to wipe the display
area. Place a small amount of plastic cleaner on a
soft cloth and wipe clean. Again, avoid using
petroleum based solvents such as acetone, benzene
or tricloroethylene. They contain chemicals that can
etch plastic surfaces.
15