INSTRUCTION HANDBOOK - Utax

Copy Functions
3 Check the orientation of the original.
NOTE: Incorrect copying may occur if the original is not placed correctly.
4 Press [Close].
Finish
Set the Finish options. The following settings are available.
• Offset (Group) – Each completed set is rotated 90 degrees to the next before stacking.
• Stapling – Use the optional document finisher or 3000 sheet document finisher to staple the
completed copies.
• Bind and Staple – Use the optional 3000 sheet document finisher and folding unit to bind&fold
(fold the finished copy in half and staple).
• Punching – Use the 3000 sheet document finisher and punching unit to hole punch the
completed copies.
1 Press [Basic]. On the next screen, press [Finished].
NOTE: Finish settings are common for all steps. It may only be configured as the first step.
2 For finishing, press [On] ([1 set]). For further details, refer to Offset Mode on page 1-9.
For stapling, press [Staple Mode] and complete the settings. For further details, refer to Stapling on
page 1-10.
For punching, press [Punch Mode] and complete the settings. For further details, refer to Punching
on page 1-12.
For center margin stapling, press [Saddle Stitch] ([Centre Staple]). Press [Bind & Fold].
3 Check the orientation of the original.
NOTE: Incorrect copying may occur if the original is not placed correctly.
4 Press [Close].
Reducing/Enlarging
Select the desired magnification.
1 Press [Basic]. On the next screen, press [Reduce/Enlarge].
2 Select the desired magnification.
For instructions on reducing/enlarging, refer to Reducing/Enlarging in Chapter 3 of Operation
Guide.
3 Press [Close].
Original Orientation
Check the orientation of the original.
1 Press [Basic]. On the next screen, press [Orig. Set Direction].
2 Select [Top Edge] ([Back Edge]) or [Left Top Edge] ([Left top corner]).
1-63