Chapter 1. IBM Flex System FC3171 8 Gb SAN Switch - QLogic

Table 18. Call Home Setup dialog fields (Continued)
Setting
Secondary SMTP:
Secondary SMTP Server
Address:
Secondary SMTP Server Port:
Contact Email Address:
Phone Number:
Street Address:
From Email Address:
ReplyTo Email Address:
Value
The Secondary SMTP is the second SMTP server. If the
primary SMTP is not enabled/defined, or if there was a
failure in communicating with the primary SMTP
server, the Secondary SMTP server will become the
(active) SMTP server—the one used by Call Home for
the next attempt to transmit Email.
The IP address of the secondary (second) SMTP server.
The service port number that the secondary SMTP
server is listening on to accept connection from SMTP
sending agents.
The Email address of the point-of-contact for the
switch. This Email address will be included in the text
of Email messages using the FullText format under the
section for Contact Information.
The phone number of the point-of-contact for the
switch. This value will be included in the text of Email
messages using the FullText format under the section
for Contact Information.
The address of the point-of-contact for the switch.
This value will be included in the text of Email messages
using the FullText format under the section for
Contact Information.
The Email address that will be provided to the SMTP
server to indicate the sender of the Email being transmitted.
In Emails sent by Call Home, this address will
appear in the message heading as the "From: " address.
This value is required to send Emails. If there are any
problems encountered in routing the Email to any of
the intended recipients, the notice of the problem will
be sent to this address. It is an important address for
receiving Email notices concerning problems.
This address is also the default address used when
replies are sent to an Email by a recipient. If the
"Reply-To: " Email address is supplied it will override
the sending of replies to the "From: " Email address by
recipients. However, any notifications of Email problems
sent by any SMTP server used to route the message
to the final recipient will always send those
notifications to the "From: " address.
The Email address used by mail reading programs to
determine the address that an Email should be
addressed to for a reply to a received message. This
value will override the use of the "From: " address as
the recipient for a reply message.
76 IBM Flex System FC3171 8 Gb SAN Switch QuickTools User’s Guide